IMPORTANT SAFEGUARDS
When using your Personal Trimmer, basic precautions should always be
followed, including the following:
READ ALL INSTRUCTIONS BEFORE USING.
WARNING
1. Close supervision is necessary when this trimmer is used by, on, or near
children or disabled persons.
2. Use this trimmer only for its intended use, as described in this manual.
3. Do not use this trimmer with a damaged or broken blade, as injury may occur.
4. When discarding an old battery, do not throw it into fire where heat could
cause it to rupture or explode. Also, do not attempt to recharge alkaline, heavy-
duty or regular batteries in a nickel-cadmium battery charger.
5. Risk of fire and burns. Do no recharge, disassemble, or incinerate. Keep
battery out of reach of children. Dispose of used batteries promptly.
SAVE THESE INSTRUCTIONS
BATTERY INSTALLATION/ REPLACEMENT
1. Remove battery cover from trimmer by pushing in and back on the plastic door
in the direction of the arrow.
2. Remove battery from the unit and dispose of properly.
3. Insert one AA battery negative (-) end first, so that it depresses the spring at the
top of the battery compartment. Then slide the positive (+) end into position
between the plastic ribs.
4. Replace the battery compartment cover.
5. To maximize battery life, turn the trimmer "OFF" immediately after each use.
6. Replace the battery as soon as you notice the trimmer running slower than
normal, to avoid pulling of hairs
INSTALLATION OF TRIMMING HEADS
1. Make sure trimmer is turned "OFF".
2. Holding the top half of the body, turn the trimmer head counterclockwise and
lift off.
3. Holding the top half of the body, place trimmer head on trimmer and turn
trimmer head clockwise turn to lock on.
TRIMMER TESTING: All Wahl trimmers are tested before they leave our
factory. Often, testing materials or grinding compound may be found on the
blades. Clean this off before using the trimmer.
BEFORE TRIMMING: The completely sealed trimmer can be used in the
shower. The MicroCut ® cutting system trims from both the end and the sides, so
always remember to trim slowly. Remove the protective cap and turn the trimmer
"ON" by pushing the top button.
LIGHTED HEADS: The light automatically comes on when the unit is turned
on. Use the light to see the hairs better.
TRIMMING EYEBROWS: Move the Rotary, Reciprocating, or Detail Head
slowly to trim stray eyebrow hairs. For precise, even trimming of the entire
eyebrow, move the trimmer closer or farther away to achieve the desired length.
If your kit includes an eyebrow guide comb, it can be used to effectively trim the
eyebrow.
USING EYEBROW GUIDE: Place eyebrow attachment comb over the detailing
attachment. The attachment comb allows you to trim and shape eyebrows. Trim
by following in the direction of hair growth.
NOTE: Only use on eyebrows. Be cautious around the eye area. Dots molded on
the detailing head attachment and on the eyebrow attachment may not always
line up straight with dots. The Eyebrow Attachment Comb has two settings;
approximately 2mm (S) and 4mm (L). The settings will create very short lengths
to create a thin brow.
TRIMMING HAIR FROM NOSE: Make sure the nasal passages are clean.
Slowly move the trimmer in and out of each nostril, no more than 1/4". Keep the
side of the cutting head firmly against the skin to reduce tickling sensation.
TRIMMING HAIR FROM EARS: Make sure the outer areas of the ears
do not contain any wax. Hold the ear flat with one hand and carefully insert Rotary
Head no more than 1/4-inch into the outer ear. CAUTION: Do not insert the Rotary
Head or any other foreign object into the inner ear. For hair growing on the outside
of the ear, simply move the Rotary Head slowly along the edges of the ear (either
cutting head may be used to trim hair from ears).
SIDEBURNS AND MUSTACHE: For trimming sideburns slowly move
Reciprocating Head across desired area.
CLEANING YOUR TRIMMER: Periodically, turn the trimmer "OFF" and
rinse the cutting head under warm, running water. For more thorough cleaning,
remove the cutting head assembly by turning it slightly counterclockwise. Then
rinse the entire assembly under running water. After cleaning, replace the cutting
head assembly and wipe the entire trimmer dry with a soft cloth. Always replace
the protective cap before storing.
SERVICE AND REPAIR
If you have problems with your trimmer, send it prepaid with a note explaining
the problem to:
Wahl Clipper Corporation
Attn: Repair Department
3001 Locust Street
P.O. Box 578
Sterling, IL 61081
3-YEAR LIMITED WARRANTY (Valid in U.S.A. Only)
If your Wahl product fails to operate satisfactorily within three (3) years from the
date of original purchase or receipt as a gift, Wahl will, at our option, repair or
replace it and return it to you FREE OF CHARGE. Our warranty does not cover
blades, which are wear out parts. Please mail your product prepaid to Wahl
Clipper Corporation, 3001 Locust Street, Sterling, Illinois 61081, Attention: Repair
Department, with a note describing the defect and the date of original purchase
or receipt as a gift (if in warranty). Products out of warranty will be repaired at
our standard repair charges.
This warranty is void and no repair or replacement will be made under this
warranty or otherwise if:
1. The product is modified in any manner or repaired by anyone other than Wahl
Clipper Corporation or Wahl authorized service center.
2. The product has been used commercially or subjected to unreasonable use.
This warranty gives you specific legal rights and you may also have other rights
which may vary from state to state. No other written express warranty is given.
Any implied warranty, including any warranty of merchantability which may
arise from purchase or use is limited to the years period provided in the express
warranty. Some states may not allow such limitation, so it may not apply to you.
No responsibility is assumed for incidental or consequential damages of any
type or for the use of unauthorized attachments. Some states may not allow the
exclusion or limitation of incidental or consequential damages, so the limitation
or exclusion may not apply to you.
WAHL CLIPPER CORPORATION
World Headquarters
P.O. Box 578 • Sterling, Illinois
61081
For more information or Product Registration, visit grooming.wahl.com
© 2015 Wahl Clipper Corporation
Part No. 58928-401
Printed in China
grooming.wahl.com
Ear, Nose & Brow
MicroCut ™ Rotary Head
Automatic Light
(not on all models)
Cutting Head Assembly
The trimmer you
purchased may not have
all of these heads, but
they will all work with
ON/OFF Switch
your trimmer if you wish
to purchase them.
Battery Compartment
(on backside)
Protective
Cap
Eyebrow
Guides
Detail Head
Reciprocating
Head
OPERATING INSTRUCTIONS